Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateFast, Reliable Electric Gate Repair Across San Bernardino
An electric gate that won’t open or close in San Bernardino usually comes down to one of three things: a failed motor, a control board that stopped communicating, or a mechanical issue caused by the city’s famously rough wind corridor out of Cajon Pass. We fix all three. Gate Repair Rialto sends gate-only technicians to San Bernardino daily, and we carry parts for LiftMaster, Viking, Ghost Controls, DoorKing, and Elite systems on the truck. If your gate’s dead, stuck mid-cycle, or making a grinding sound, call (866) 569-6584 and we’ll diagnose it properly the first time.
Why Gate Repair Rialto Is San Bernardino’s Preferred Electric Gate Repair Company
San Bernardino property owners deal with gate problems that a generalist won’t catch. The Santa Ana wind corridor bends tracks, shears hinges, and pushes solid infill gates hard enough to snap older hardware. The expansive clay soil shifts posts. The summer heat dries out lubricants and oxidizes electrical contacts. Our technicians know these failure patterns because we see them every week across 92401, 92404, and the foothill neighborhoods below 92407. We’re not a garage door company that also does gates. We’re not a fencing crew that dabbles in motors. We’re gate specialists. Ruben Ochoa built Gate Repair Rialto around one trade, and it shows in how quickly we diagnose boards, sensors, hinge geometry, and track alignment on systems installed across San Bernardino’s mid-century housing stock.
We answer calls from San Bernardino six days a week, and our techs typically reach most neighborhoods within 60 to 90 minutes for emergency diagnostics. When you call, you’ll talk through the symptom first. If the gate is stuck open, we’ll walk you through the safe manual release before we dispatch, which means your driveway isn’t left unsecured while you wait. That matters in San Bernardino, where a gate stuck open is a real security issue, not just an annoyance.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Electric Gate Motor in San Bernardino
Electric gate motor repair in San Bernardino is one of the most common calls we take. A typical motor replacement or rebuild runs $450 to $1,600 depending on the operator brand, the gate’s weight, and whether the motor is AC or DC. Most San Bernardino homes built between the 1950s and 1970s have original or first-replacement gate operators that are now 15 to 25 years old. The inland heat bakes the motor windings, and dust blown in from the Cajon Pass gets into the housing and accelerates bearing wear. In the foothill ZIP codes, we frequently see motors that were never sized for wind loads. A solid infill gate acts like a sail in a 60 mph gust, and an undersized motor will burn out repeatedly until the problem is addressed at the source.
Motor Diagnostics and Replacement
We start with a load test to see whether the motor is drawing too much current, which usually points to a mechanical bind somewhere in the gate’s travel. If the motor tests fine but the gate won’t move, the issue is often the capacitor or the control board. We diagnose before we quote, so you’ll know whether we’re replacing the motor, rebuilding it, or fixing something upstream.
Wind-Load Motor Upgrades
For solid panel gates along the 215 corridor and exposed streets near the base of the foothills, we often recommend a higher-torque motor paired with a wind-rated hinge and track setup. This isn’t an upsell. It’s the difference between a gate that cycles smoothly for another decade and one that burns out again next October when the Santa Anas hit.
Gate Access Control in San Bernardino
Gate access control in San Bernardino covers keypads, remote receivers, intercom systems, vehicle loop detectors, and the safety sensors that prevent a gate from closing on a car or a person. A typical access control repair runs $180 to $450 for keypad or receiver work, and $350 to $900 for control board replacement or loop detector repair. San Bernardino’s wind-driven dust is tough on outdoor keypads. The membrane contacts dry out in the heat, and grit works into the housing until the buttons stop responding. Older systems in the mid-century tracts off Del Rosa Avenue and Sierra Way often run on legacy wiring that’s more than 30 years old, and the connections corrode at the junction points.
Keypad and Receiver Repair
We work on Viking, Ghost Controls, DoorKing, and Elite access control hardware, plus a long list of other systems. Most keypad failures are either worn contacts or water intrusion at the seal. If the receiver isn’t picking up remotes, we check frequency drift and antenna placement before replacing components. On older systems, we can often repair rather than replace, which saves San Bernardino homeowners hundreds of dollars.
UL 325 Safety Compliance
San Bernardino electric gates need to meet UL 325 safety standards, which means operational photoelectric sensors and properly adjusted entrapment protection. After any repair, we run a full safety check to confirm the gate reverses on contact and that the photo eyes are aligned and functional. If your gate is slamming shut or failing to detect a vehicle, call (866) 569-6584 before someone gets hurt.
Trusted Brands We Service in San Bernardino
Your gate brand, our expertise. Gate Repair Rialto is certified to service nine major gate and operator brands, and we carry or can quickly source parts for LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. What that means for San Bernardino homeowners is simple: we diagnose correctly the first time, whether your opener was installed twenty years ago or last season. We don’t force generic hardware into a system it wasn’t built for. If you’ve got an older Viking operator in the 92404 foothills or a DoorKing swing arm on a commercial property near Hospitality Lane, we know the wiring, the board layouts, and the failure points. That’s the advantage of a shop that only does gates.
Common Electric Gate Repair Problems We See in San Bernardino Homes
- Wind-bent tracks and sheared hinges from Santa Ana events. Solid infill gates in the mid-century tract neighborhoods off the 210 and 215 get hammered by gusts funneling out of Cajon Pass. We routinely rebuild track sections and replace hinge pins that snapped during 60 to 70 mph wind events.
- Posts pushed out of plumb by mature tree roots. In the foothill neighborhoods of 92404, 92405, and 92407, ficus and palm root systems grow into gate post footings and slowly shove them out of alignment. The operator then fights a binding gate every single cycle, and the motor or board eventually fails. We reset posts, not just hinges.
- Dust and grit inside motor housings and rollers. San Bernardino’s semi-arid climate means fine dust works its way into every moving part. We disassemble, clean, and re-lubricate roller assemblies and motor gears far more often here than in coastal cities.
- Control board failures after winter rain saturation. When winter rain soaks the expansive clay, posts shift, gates bind, and boards burn out trying to move a gate that won’t budge. We test the board, then check the mechanical alignment underneath it.
See the difference
Before
After
Before
After
Before
AfterPricing for Electric Gate Repair in San Bernardino, CA
Here’s what San Bernardino homeowners can expect to pay. Motor replacement runs $450 to $1,600. Control board repair or replacement is $350 to $900. Keypad and remote receiver work falls between $180 and $450. Safety sensor repair or replacement typically runs $150 to $350. Hinge and track repair after wind damage is $200 to $800 depending on the extent. Post resetting, which we do often in the foothill ZIP codes, runs $500 to $1,500 when excavation and concrete work are involved. We quote every job before we start, and the price we give you is the price you pay. Free estimates are available by phone. If you’re comparing prices with nearby cities like Colton or Highland, San Bernardino’s costs are comparable; the difference is that our crews know what the wind and soil do to gates here, which means fewer return visits.
We Also Serve Cities Near San Bernardino
Gate Repair Rialto covers San Bernardino and the surrounding communities, including Colton, Highland, Rialto, and Redlands. If your property is a few blocks off the San Bernardino city line, you’re still in our service area. For more on our full coverage and service details, see our Electric Gate Repair page or learn about what we handle across San Bernardino.
Serving San Bernardino, CA – Our Local Coverage Area
We’re based in the San Bernardino area and know this community well. Use the map below to see our service coverage – if you’re nearby, we can almost certainly help.
FAQs About Electric Gate Repair in San Bernardino
Santa Ana winds bend the gate tracks, shear hinge pins, and stress the operator until something mechanically or electrically fails. On solid infill gates, the wind load pushes against the entire panel surface. If your hinges or track are even slightly out of alignment, the motor has to work harder every cycle, and eventually the board or motor burns out. For San Bernardino properties in wind-exposed areas, we recommend a wind-rated reinforcement kit and a track realignment. Call (866) 569-6584 and we’ll inspect your gate for wind damage and give you a straight answer on what’s failing.
Most electric gate operators have a manual release mechanism, usually a keyed release or a pull handle on the operator housing. Turn off the power to the operator first, then activate the release and push the gate by hand. If you’re not sure where the release is, don’t force anything. Call us at (866) 569-6584 and we’ll walk you through the exact procedure for your operator brand over the phone. We’d rather talk you through it than have you damage a gearbox or strip a release mechanism.
Yes. It’s one of the most common problems we see in San Bernardino’s foothill neighborhoods like 92404, 92405, and 92407, where mature ficus and palm roots push against gate post footings until the post goes out of plumb. In the 92405 neighborhood off the 210, a homeowner’s LiftMaster swing gate operator started stalling after winter rains. We found the hinge post pushed out of plumb by ficus roots and the footing undermined by saturated clay. We reset the post, realigned the track, and installed a wind-rated reinforcement kit. The gate now cycles smoothly even in Santa Ana gusts. If your gate leans or scrapes near the base, that’s worth checking before you keep replacing operators.
Every electric gate in San Bernardino should have working photoelectric sensors or another entrapment protection device, plus a properly adjusted auto-reverse function. UL 325 compliance also requires warning signage for commercial properties and installation of an emergency manual release in some cases. After every repair, we test the full safety loop: photo eyes, edge sensors if present, and the reversing mechanism. If your gate doesn’t stop and reverse when it meets resistance, call us before someone gets injured. It’s a genuine safety issue, not a convenience feature.
Yes. We service Viking, Ghost Controls, DoorKing, and Elite systems, plus LiftMaster, FAAC, BFT, Linear, and Mighty Mule, and we regularly work on operators that are 15 to 25 years old. Older boards and motors can often be repaired or rebuilt rather than replaced, especially if the failure is a capacitor, a relay, or a dry solder joint. Even when a part has been discontinued, our brand-specific sourcing means we can usually locate a compatible replacement rather than forcing a new operator on you. Call (866) 569-6584 with your model number and we’ll tell you what we can do.
Get Your San Bernardino Gate Back to Working Order
If your electric gate won’t open, won’t close, or is making a noise you haven’t heard before, don’t wait for the next Santa Ana event to finish the job. Call Gate Repair Rialto at (866) 569-6584. We’ll diagnose the problem over the phone, give you an honest price range, and get a gate-only technician to your San Bernardino property fast. Free estimates, upfront pricing, and no guesswork.
Written by Ruben Ochoa, Owner at Gate Repair Rialto, serving San Bernardino with gate-only expertise.